Fuel Flow Sensor with 10' cable &
T-connector
Fuel Flow Sensor Gasoline ONLY. 1 required per engine. Up
to 3 engines supported.
Outputs:
- Fuel Flow
- Tank Fuel Used
- Trip Fuel Used
- Seasonal Fuel Used
Cable Length: 10'
Fuel Line
Diameter:
3/8" (9.5mm) Inside Diameter
Flow Rate Measured:
Optimized for 0.6-45 Gal/hr but can measure outside these values
Added
Back Pressure to the fuel system:
0.5 PSI at 20 Gal/hr; 1 PSI at 40
Gal/hr
Installation Location: Above the max level of the fuel tank,
in-line after the fuel filter and any Y's or T's in the line
Package:
The Fuel Flow Sensor, N2K T and 2 (two) 1" hose clamps
Fuel Type:
Gasoline only. The Fuel Flow Sensor does not operate diesel engine fuel
systems
Hole required to route through a bulkhead: 22mm
(7/8")
Multiple Fule Flow sensors possible: Yes
WARNING:
This product can expose you to chemicals including Di-n-hexyl Phthalate (DnHP)
which is known to the State of California to cause reproductive harm, and
Vinyl Chloride which is known to the State of California to cause cancer. For
more information go to 
