Lenco 101 Standard Actuator, 24V, 2-1/4" Stroke 15061-001
101 Standard Actuator
5/16" (.79 cm) mounting hardware
Stroke: 2-1/4" (5.72 cm)
Length overall: 12-1/8" (30.80 cm)
Length pin to pin: 11-1/2" (29.21 cm)
Diameter (upper housing): 2-1/2" (6.35 cm)
Mounting hardware: 5/16" ( .79 cm) or Delrin Pin (Part #121)
Part # (Superseded #)
15061-001(101-3), 24 Volt w/6' (1.83 cm) cable with Deutsch connector & mounting
hardware(replacement length)
- Top cap gland seal sheaths the actuator cable outer jacket as well as both
internal conductors for maximum waterproofing
- Corrosion proof Vandar mounts
- Stainless steel ram won't flex, even under extreme loads
- Double O-ring for maximum protection
- Ballscrew rotates freely on 12 ball bearings at both ends of its stroke so
there's no need for complicated limit switches and clutches
- Self-locking ballscrew locks into position and will not drift
- Precision molded, powdered metal, high alloy gears provide high accuracy,
high wear resistance, and high strength for long life
- Tough, high-torque motor easily transfers 750 lbs
- High-impact, ultraviolet resistant nylon 66, 50% glass fiber reinforced
thermoplastic housing
- Corrosion proof Vandar cap and mount, stands up to severe loads
|
WARNING:
This product can expose you to chemicals including Di-n-hexyl Phthalate (DnHP)
which is known to the State of California to cause reproductive harm, and
Vinyl Chloride which is known to the State of California to cause cancer. For
more information go to 
