Cable for Smart BMS CL 12-100 to MultiPlus
This cable will allow the MultiPlus 500VA – 1600VA, MultiPlus Compact 800VA –
2kVA and MultiPlus-II models to be used with BMS products that have no VE.Bus
interface, such as the Smart BMS CL 12-100 and the small BMS. These MultiPlus
models can be controlled from the Load/Charge Disconnect outputs and
Load/Charger outputs respectively.
The cable must be wired to the remote on/off connector of the MultiPlus models:
-
When used with the MultiPlus 500VA-1200VA models connect the black wire to the
ON terminal and the red wire to the (+) terminal.
-
When used with the MultiPlus Compact 800VA-2kVA models connect the black wire
to the middle terminal and the red wire to the right (IN) terminal.
-
When used with the MultiPlus-II models connect the black wire to the lower (-)
terminal and the red wire to the upper (+) remote on-off terminal.
Both the Load/Charge Disconnect outputs of Smart BMS CL 12-100 and Load/Charger
outputs of the small BMS must be in ‘High’ state in order for the MultiPlus to
operate. After shutdown due to low battery voltage, run the alternator or use a
battery charger on the primary side of the BMS to reset the system. The
MultiPlus will then switch on and start charging (if connected to an AC power
source).
WARNING:
This product can expose you to chemicals including Di-n-hexyl Phthalate (DnHP)
which is known to the State of California to cause reproductive harm, and
Vinyl Chloride which is known to the State of California to cause cancer. For
more information go to 
