WASTE EVACUATION
The Jabsco 18590 series DC macerator pump unit
is the ideal solution for emptying marine holding tanks when not in a discharge
restricted area. Self priming to 5ft this pump will empty a typical 30 gallon
(115 Liter) holding tank in less than 3 minutes. Duty cycle of the pump is 15
minutes continuous which means a 180 gallon (680 liter) can be emptied in a
single operation
It is recommended that holding tanks be
flushed with several gallons of water after each pump out. This will reduce the
possibility of a continued build up of sediment in the tank which could cause a
potential blockage.
FISH BOX AND LIVEWELL TANK EVACUATION
The Jabsco Macerator Pump is the ideal pump
for the emptying of Fish box and livewell receptacles. Very often the livewell
tank will be above the waterline of the boat, when this is the case gravity can
be used to empty the livewell tank. If not installed in this format then it is
beneficial to use the Jabsco macerator pump for evacuation due to its
self-priming capabilities and also it's grinding properties.
Fish boxes are typically mounted into the
floor of the vessel and are very often below the waterline or only partially
above the waterline. Again the Jabsco Macerator pump has the characteristics
that lend themselves to this application. The bait residue particles of ice,
fish scales and anything else that could potentially be found in the Fish-Box
will be easily passed buy the Jabsco Macerator Pump, and the self priming
capabilities are perfect for fish box installations common to many of today's
sports fishing boats.
Features:
• Impeller: Jabsco Nitrile compoundNEW
• Macerator: Stainless Steel Cutter reduces particle size to 1/8" (3mm) maximum.
New 4blade design.
• Seal: Lip Type
Specifications:
|
|
|
Pump
|
|
Self-Priming
Flexible Impeller with Stainless Steel Wearplate
|
|
Port(s)
|
|
Inlet - 1-1/2"
(38mm) Hose Barb and 1-1/2" N.P.T. (Male) Outlet - 1" (19mm) Hose Barb;
|
|
Motor
|
|
Permanent Magnet
Type, Fully Enclosed, with Stainless Steel Shaft Includes Run-Dry Protection
Device that shuts-off pump. Powder coated housing with sealed end-bells and
bearings. Complies with USCG Regulation 183.410 and ISO 8846 MARINE for
Ignition Protection.
|
|
Weight
|
|
5 lb 2.3
kg
|
Specifications:
|
|
|
Voltage
|
|
12 EMC
|
|
Amp Draw
|
|
16 A
|
|
Fuse Rating
|
|
20 A
|