icom M411BB Black Box VHF with HM195GB CommandMic
Model: M410 BB 11 USA
Icom’s M410BB is a flexible black box fixed mount that provides VHF
communications for vessels with limited helm space. The supplied CommandMic™
controls the radio for essential communications on the water.
The M410BB consists of a CommandMic™ and black box RF unit. Use the CommandMic™
for all operations including DSC. Install the RF unit out-of-sight, place up to
60 ft (18.3 m)* away from the CommandMic™.
Add an additional CommandMic™ to extend communication points for boats requiring
a second comms station. This is ideal for boats needing communication between
the cockpit and other locations on the boat. Access the intercom functions for
one-to-all or one-to-one communications on the boat.
On the back of every CommandMic™ is a conveniently located DSC button. Once
triggered, the M410BB transmits a DSC alert signal to nearby vessels with the
MMSI* and GPS location of your vessel.
The NMEA 2000® network provides plug-and-play data communication to
inter-connect other marine equipment such as an MFD (Multi-Function Display).
The radio can send AIS, GNSS (GPS) position, DSC call, and radio channels to
other equipment.
The built-in 15W amplifier increases the audio output of an external hailer
speaker. The one-way RX hailer function enables you to broadcast radio traffic
through the hailer speaker to listen to radio traffic on the deck or tower. You
can also sound foghorn patterns from the hailer speaker.
The Active Noise Cancelling function digitally removes background noise from
transmitting and receiving audio to provide clear communications in noisy
maritime environments.
Specifications
|
General
|
|
Usable
channels
|
USA, INT,
CAN, WX channels
|
|
Power
supply requirement
|
13.8 V DC
nominal (11.7 ~ 15.9 V DC) (Negative ground)
|
|
Current
drain (at 13.8 V DC)
|
TX Max.
power - 5.5 A Max.
RX Max. audio - 1.5 A (One CommandMic™) 4.0 A (Two CommandMic™ and RX
hailer)
|
|
Operating
temperature range
|
—20°C ~
60°C, —4?F ~ 140?F
|
|
Antenna
impedance
|
80 ohm
nominal
|
|
Weight
(approx.)
|
RF unit -
890 g; 2 lb
CommandMic™ - 400 g; 14.1 oz
|
|
Transmitter
|
|
Output
power (at 13.8V DC)
|
25 W, 1 W
(High, Low)
|
|
Max.
frequency deviation
|
±5 kHz
|
|
Frequency
tolerance
|
±0.5 kHz
|
|
Spurious
emissions
|
Less than
—70 dBc (High power), Less than —56 dBc (Low power)
|
|
Residual
modulation
|
More than
40 dB
|
|
Adjacent
channel power
|
More than
70 dB
|
|
Receiver
|
|
Sensitivity
FM (at 12dB SINAD)
|
0.22 ?V
typical
|
|
Sensitivity
DSC (at 1% BER)
|
—7 dB? emf
typical
|
|
Adjacent
channel selectivity FM
|
More than
70 dB
|
|
Adjacent
channel selectivity DSC (1% BER)
|
More than
73 dBµ emf
|
|
Spurious
response FM
|
More than
70 dB
|
|
Spurious
response DSC (1% BER)
|
More than
73 dB? emf
|
|
Intermodulation FM
|
More than
75 dB
|
|
Intermodulation DSC (1% BER)
|
More than
68 dBµ emf
|
|
Hum and
noise
|
More than
40 dB
|
What's in the Box:
- IC-M410BB
- DC power cable (2 m)
- Microphone Hanger
- Connection cable, OPC-1540
(6.1 m, 20 ft)
- CommandMic™, HM-195G
- Connector cap
- Mounting base
Comparison ICOM410BB11USA_Comparison.pdf
Data
Sheet
ICOM410BB11USA_DataSheet.pdf
WARNING:
This product can expose you to chemicals including Di-n-hexyl Phthalate (DnHP)
which is known to the State of California to cause reproductive harm, and
Vinyl Chloride which is known to the State of California to cause cancer. For
more information go to 
