Mobile DC UPS
Mobile Data Power System
The Mobile Data Power, model MDP-25, is a DC UPS that solves
the common problem of lengthy reboot sequences, system crash, data and hard
drive corruption in mobile computer work stations due to a low voltage and loss
of power as a result of intermittent or poor vehicle battery condition. In
addition, the MDP provides a low voltage output warning signal to terminals
(such as Motorolaฎ MW 800 series work stations) allowing orderly automatic
shutdown of the powered device, protecting data and preventing hard drive
corruption.
Utilizing a high speed sensor circuit, when primary vehicle
voltage drops below a critical point, the internal 9AH battery is switched
on-line in milli-seconds, assuring no interruption to the powered device(s). The
MDP-25 has an internal 3 step, temperature compensated charger that maintains
its reserve battery at full charge, ready to go on-line when a fault or
degradation of primary vehicle battery occurs. This functionality assures
continued operation of mobile computers under a variety of adverse vehicle
battery conditions.
Housed in a rugged aluminum case and heavy duty mounting
plate, the unit is designed for installation in emergency vehicles, service and
other utility vehicles that require a steady source of voltage for mobile
computers, work stations, and electronics.
Protects mobile computers
against system crash, lengthy reboot
sequences, and loss of data due to:
Voltage dip during engine cranking
Voltage drop and decay due to loading high power accessories, and aging
batteries
Voltage loss due to cycling of master disconnect switch and battery failure.
Provides supplemental voltage
in milli-seconds to mobile data devices
when low vehicle battery is sensed.
Immediately augments power to electronics when needed and fully powers
electronics
if critical low voltage condition persists.
Built-in Multi-Stage filter
provides clean power required by mobile electronics
Eliminates noise and interference
Transient protection prevents damage to sensitive circuitry due to voltage
spikes
Provides output warning signals
to mobile computers (such as Motorolaฎ
MW 800 series work stations)
Initiates low voltage shut down sequence in mobile computer, protecting data
and hard drive.
Alerts when system is operating on battery back-up
Internal 3 stage, temperature
compensated charger maintains back-up
battery in fully charge stand-by state.
Provides isolated power source, 12 volts @ 5 amps for 60 minutes, 10 amps for
20 minutes, 25 amps for 8 minutes
Battery easily accessed by front panel door
Model MDP-25
Input range: 10.2V 15.5V (start-up @ 11.5V)
Standby Current Draw: <50mA
Output: 12 VDC
Maximum Load Current: 25 amps
Battery Connect Sequences:
Internal battery switches online when vehicle battery voltage = 10 V ฑ 1 V
(Vehicle battery disconnects after 3 seconds if low voltage condition
persists)
Vehicle battery reconnects @ 11.5 V ฑ 1 V
Internal Battery Low Voltage Disconnect: < 9.6 V
Battery Specification:
9 AH, sealed Lead Acid typical life 5 years, easily replaced via front panel
access door.
Power delivery @ > 10.2 volts @ 25ฐC
5 amps @ 60 minutes
10 amps @ 20 minutes
25 amps @ 8 minutes
Output Signals for terminals (such
as Motorolaฎ 800 series work stations):
When imminent Voltage decay to 11.5 VDC is projected (adjustable set point)
On Charge/Discharge
Internal Battery Charger:
Charge Current: 2 amps max., three-stage
(Bulk, Absorption, Float)
Temperature Compensated
Temperature rating:
Operating 0 50ฐ C
Mechanical:
Aluminum case with access door for easy removal of battery
Heavy duty mounting suitable for commercial vehicle use
Size: 5.75 H x 6 W x 8.5 D; (14.6 x 15.24 x 21.59 cm)
Weight: 9.4 lbs.
Options:
Remote LED indicator panel
Power OK
Operating on Back-Up
WARNING:
This product can expose you to chemicals including Di-n-hexyl Phthalate (DnHP)
which is known to the State of California to cause reproductive harm, and
Vinyl Chloride which is known to the State of California to cause cancer. For
more information go to 
