VETUS Outboard Steering Set, HTP3010RB Pump, OBC300 Cylinder, Oil, Hose & Coupling, OB300SET
The VETUS hydraulic steering system for outboard motors
consists of a steering pump with integrated non-return and pressure relief
valves, plus a steering cylinder and connection hoses to the required length.
Cylinders are available for outboards up to 175 hp and, up to 300 hp and feature
a stainless steel piston rod with a sea water resistant anodized aluminum
housing.
The steering pumps are also provided with a continuous air bleeding point. The
pump and the cylinder are connected with nylon hydraulic hose which can be
ordered to length. The compression fittings to take these hoses are standard
supply with the pump and with the cylinder.
A boxed
outboard steering set consists of:
• one steering pump
• one cylinder
• 30 ft. of nylon hose Ø 8 x 12 mm
• 4 connectors
• incl. 0.66 gal. of hydraulic oil
|
| Instead
of a standard set, individual components may be ordered to your own
specification. In this case you will be able to decide on the required
number of steering wheel revolutions from hard over to hard over.
|
Maximum rudder
torque 760 ft.lbs.
Cylinder volume:
10.6 in3
A single OBC300 cylinder can operate a twin outboard motor
installation. If both propellers rotate in the same direction, the total output
of the engines should not exceed 300 hp. If the motors have counter-rotating
propellers, the maximum combined power can be 600 hp. The OBC175 cylinder can
also be used for twin installations, but in this case the joint maximum output
is limited to 175 hp or 350 hp for counter-rotating propellers.
|
WARNING:
This product can expose you to chemicals including Di-n-hexyl Phthalate (DnHP)
which is known to the State of California to cause reproductive harm, and
Vinyl Chloride which is known to the State of California to cause cancer. For
more information go to 
