Extreme heavy duty cylinders and tiebars designed for primarily high
performance multiple engine applications. Also available for single engine
applications
Product Datasheet
CONFIGURATION |
CYLINDER |
HARDWARE KIT |
TIE
BAR |
NOTES |
PART NO. |
QTY. |
PART NO. |
QTY. |
PART NO. |
QTY. |
CENTER TO CENTER
DISTANCE (IN.) |
CENTER TO CENTER
DISTANCE (MM.) |
Single Engine |
HC6845S |
1 |
Included |
|
|
N/A |
N/A |
N/A |
See Note 1 |
Twin Engine Single Cylinder (STBD) |
HC6845 |
1 |
HA6802 |
1 |
HO6821 |
1 |
25.0 25.6 |
635 650 |
See notes 1,3,4,5 HA6802 Drive Bracket Availability TBD |
HO6822 |
25.7 30.6 |
653 777 |
HO6823 |
30.7 39.0 |
780 991 |
Twin Engine Dual Cylinder |
HC6845 |
2 |
HA6804 |
1 |
HO6820 |
1 |
25.0 26.5 |
635 673 |
See notes 1,3,4,5 |
HO6821 |
26.6 29.3 |
676 744 |
HO6822 |
29.4 34.2 |
747 869 |
HO6823 |
34.3 43.0 |
871 1092 |
Triple Engine Dual Cylinder |
HC6845 |
2 |
HA6806 |
1 |
HO6822 |
2 |
25.0 27.9 |
635 709 |
Maximum drop: ≤ 3 inches (76mm) See notes 1 thru 5 |
HO6823 |
28.0 36.0 |
711 914 |
Quad Engine Dual Cylinder |
HC6845 |
2 |
HA6811 |
1 |
CONSULT TELEFLEX TECHNICAL
SERVICE |
See notes 1,3,4,5 |
Quintuplet Engine (Plus) |
CONSULT TELEFLEX TECHNICAL
SERVICE |
- See notes 1,3,4,5
|
Important Information:
Each configuration requires a hardware kit and
tie bar kit(s), with the exception of the single engine
configuration.
GENERAL INSTALLATION NOTES FOR CHART ABOVE
1) Installation may vary according to the following factors: engine
mounting height, transom thickness, use of transom savers, tiller bolt hole
location, engine tilt range, and engine size.
2) For center engine drops greater than 3 inches (76mm), please
consult Teleflex Technical Service.
3) Tie bar length may vary depending on toe in/toe out setup. To allow
for toe, add or subtract from your nominal engine center to center distance.
4) Based on recommended engine manufacturer minimum center to
center distances. Deviating from these recommendations may require
stroke limiting cylinders and/or engine tilt limiting, please consult
Teleflex Technical Service.
5) Cylinders must be plumbed in parallel only, no series connections.
Only exception is if cylinders are utilizing a liquid tie bar.