The “1700 Series”
water heater provides hot water for galley
and shower. Dense foam
insulation provides
better and longer heat retention than
traditional fiberglass. The tank
itself is protected
by a 75 PSI T& P ( temperature and pressure) relief
valve. The cylindrical
design of the tank
enables it to withstand more pressure than a
cube shaped tank.
Heat exchanger
models can be connected to the engine
cooling system. This provides
the added
convenience of hot water when underway or
generator power is not available.
The innovative heat
exchanger is over seven feet in length and
is evenly coiled throughout the interior of the
tank, providing hot water
rapidly and
efficiently.
Raritan’s water
heaters use an ignition protected
thermostat. Although it is factory
set to 120°F, it is
adjustable from 110° to 160°F and has a
safety shut down limit of
190°F. All models
and sizes have the plumbing connections on the
same side to simplify
installation. Hot
and cold water connections are ľ" male NPT
(National Pipe Thread). Heat
exchanger
connections are ľ" female NPT.
Benefits
•
Simple installation – retrofits to
most on-board pressure systems
• Proven long-life design
• Withstands the rigors of the marine
environment
• Glass-lined steel tank is more
durable than stainless steel
• Attractive polymer jacket resists
corrosion from dampness
• Ignition-protected, adjustable
thermostat
•
Round tanks are designed to
withstand more pressure than
square tanks
• Glass-lined steel tank for long life
and high efficiency
• Environmentally friendly CFC-free
foam insulation
•
Replaceable magnesium anode to
protect tank and neutralize
acids in the water
• The tank is covered by a five-year
Limited Warranty
•
Each unit is assembled by hand,
individually tested and backed
by Raritan’s two-year Limited Warranty and legendary technical
support team.
Dimensions
6 gal. 14 1/2"(36.9cm) Diameter 16 1/4"(41.9cm) High
12 gal. 18 3/4"(47.6cm) Diameter 16 1/4"(41.9cm) High
20 gal. 18 3/4"(47.6cm) Diameter 24 1/4"(60.6cm) High
There is also a 1" mounting flange adding and additional 2" to the base diameter.